How to set up Collaborator Module to work with CADViewer

You need to have "CollaboratorServlet.class" servlet and "cadviewer_ent.cfg" file. If you have File Conversion Module, this "cadviewer_ent.cfg" would be the same one.

Collaborator Module

  • Copy the servlet "CollaboratorServlet.class" to your servlet container
  • Reset your servlet container
  • Use a browser to run the servlet i.e. http://xyz.com/servlets/CollaboratorServlet
  • The servlet will give you the location where you should install the conversion.cfg file
  • Copy cadviewer_ent.cfg file to the given location
  • Use an editor to modify cadviewer_ent.cfg file
  • CADViewer

  • Install CADViewer
  • In the viewer.cfg file, add the following line: